Audiovox PRO9801C Uživatelský manuál Strana 4
- Strana / 8
- Tabulka s obsahem
- KNIHY
Hodnocené. / 5. Na základě hodnocení zákazníků
128-6799C
4 of 8
4
to use, and all others are erased, you will have to fill all four receiver slots.
If in step 3 you identified one transmitter, you will have to fill the additional
3 slots. If in step 3 you identified two transmitters, you will have to fill the
additional two slots, etc...
4. Press and hold any unused button or combination of buttons until a long
chirp is heard from the siren. Release and press the button or button
combination again and again until all remaining slots are full.
Repeat this procedure with the appropriate transmitter buttons for all other
receiver channels.
REPRIORITIZING A TRANSMITTER’S PROGRAMMING:
To reprogram a receiver channel with a different transmitter button once a
code has been stored, there will be two options:
1. Enter the transmitter program mode of the receiver channel to be
reprogrammed. Using any unused button or combination of buttons, push
out the stored code by pressing the unused button until a long chirp is
heard, then repeat 3 additional times. After this, you can add any desired
unused transmitter button. This action erases only that particular receiver
channel, all other codes will remain stored.
2. Enter the transmitter program mode. Using any transmitter button press
and hold until a long chirp is heard. If a single chirp or multiple chirps, (up
to 7 chirps), are heard, the unit is indicating that the transmitter has
already been programmed elsewhere in the receiver. Release the
transmitter button and within 5 seconds press and hold until a long chirp is
heard. This action forces the unit to erase all stored codes of that
transmitter.
The unit then exits the program mode the siren emits the
program mode exit chirp pattern. All transmitter buttons
for that transmitter must now be reprogrammed. Any
other transmitter stored in the unit’s memory still remain operational. If the
button is released and not pressed again within the 5 second period, no
change in programming has been made to the receiver channel. The
programmer can move onto a different channel or erase the transmitter
codes as described in 1 above.
REPLACING THE BATTERY:
You will notice a decrease in transmitter range as the battery condition
deteriorates. There is also a low battery indicator that indicate no bars in
the LCD panel, as shown below, when the battery begins to fail. Trans-
mitter battery replacement is recommended at least every 6 to 8 months,
depending upon how frequently the transmitter is used.
Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Audiovox PRO9801C
Bezpečnostní systémy pro řízení přístupu Audiovox Prestige Platinum 128-4629B Uživatelský manuál
(188 stránky)
(188 stránky)
(24 stránky)
Bezpečnostní systémy pro řízení přístupu Audiovox Prestige Platinum 128-7401A Uživatelský manuál
(158 stránky)
(158 stránky)
Bezpečnostní systémy pro řízení přístupu Audiovox Prestige Platinum 128-7401A Uživatelský manuál
(197 stránky)
(197 stránky)
Global Upholstery Co. Kate 2811-8 podręczniki
Instrukcje obsługi i podręczniki użytkownika dla Meble Global Upholstery Co. Kate 2811-8.
Dostarczamy 1 pdf podręczników Global Upholstery Co. Kate 2811-8 do pobrania za darmo według typów dokumentów: Instrukcja Użytkownika
Komentáře k této Příručce