Installation GuideVOD12912.1” OVERHEAD LCD MONITORWITH DVD PLAYER
CONNECTING THE DOME LIGHTSThe dome lights in the video monitor require three connections to the vehicle's wiring. There are two common types of
Red / black - Lamp onTo 12 pinconnectorToconstantToconstantBlack / red - Lamp commonPurple / brown - Lamp AutoFactory Door ajarswitch or BodyControl c
© 2010 Audiovox Electronics Corp., Hauppauge, NY 11788128-8608
Important NoticeAn LCD panel and/or video monitor may be installed in a motor vehicle and visible to the driver if the LCD panel or video monitor is u
MATERIALS INCLUDED IN THIS PACKAGE:1) 12.1” TFT LCD Overhead Monitor With DVD Player - (1pc)2) 12 Pin P
(B)(B)Begin by hooking area “A” (above) over the dome light and slide the cover over the pod. The cover will snap in place.Place the pod on a soft sur
2 35Work on a soft surface to avoid damaging the plastic.Insert the supplied pry tool between the Housing and Snap On Cover (Shroud), then press the p
VEHICLE PREPARATION:1) Locate an accessory power source (+12v when key is in the ACC. and run positions, and 0v when key is off), and also a good grou
TRIM RING INSTALLATION:Note: This page only covers special installation considerations for thick trim ring installation. If the video monitor is to be
RoofRoof SupportHeadlinerMounting BracketSelf-drilling ScrewsTrim RingVideo UnitM5 ScrewMOUNTING THE TRIM RING8
1) Make the connections to the vehicle for the 12 pin wiring harness.2) Connect power harness to vehicles electrical system by tapping into an acc
Komentáře k této Příručce